07-030
3 of 5
Install the Front License Plate Holder
The front license plate holder and mounting hardware
are in the trunk. If state regulations require a front
license plate, do this:
1. Install the two clip nuts on the bumper brackets.
2. Install the holder using the two black mounting
bolts.
NOTE: The rest of the hardware in the kit is for
attaching the front license plate to the holder and
installing the rear license plate.
Set the Tire Pressures
To prevent flat spots during shipping and storage, the
tires are inflated to over 40 psi. Adjust the tire
pressures to the cold inflation pressures listed on the
driver’s doorjamb sticker. If you are in a cold climate
region, make sure the tires are at the outside ambient
temperature before adjusting the pressures; otherwise,
the TPMS low pressure indicator may show low tire
pressure in cold weather. Be sure to also check the
pressure in the spare tire.
NOTE: The spare tire does not have a TPMS sensor.
The low pressure indicator does not come on if the
pressure in the spare tire is low.
Initialize the Tire Pressure Monitoring System
If the tire pressure monitoring system (TPMS) indicator
on the instrument panel stays on when the ignition
switch is at ON (II), do this to initialize the system:
1. Start the engine, then stop it by turning the ignition
switch to LOCK (0).
2. Wait 25 seconds.
3. Repeat steps 1 and 2 seven more times.
4. Check the TPMS message in the multi-information
display; the tire pressure readings should be
normal. If the readings are abnormally high, check
for DTCs with the HDS.
Check/Refresh the XM Satellite Radio Dealer Demo
Service (All Except Alaskan and Hawaiian Models)
The XM Satellite Radio comes from the factory
activated with the dealer demo service. Once you
install the No. 15 fuse, the XM radio will receive the full
range of available XM channels. Make sure this service
is activated by checking if the radio is getting channels
000
,
001
,
007
,
009
,
047
,
122
,
174
, and
247
. If it is not,
do a rapid refresh on the
i
N (Interactive Network).
Without the dealer demo service activated, the XM
radio only displays channels
000
,
001
,
174
, and
247
.
To check for the dealer demo service, do this:
1. Turn the ignition switch to ON (II).
2. Turn on the radio, enter the 4-digit navigation anti-
theft code (if not already done), and press the XM
button.
3. Make sure the radio is in
CHANNEL MODE
, not
CATEGORY MODE
. Press and hold the DISP-
MODE button until the mode changes (without
navigation), or touch the
MODE
icon (with
navigation) to switch between modes.
4. Tune to channel
001
(the XM preview channel) to
make sure you are receiving the XM signal. If you
do not get a clear signal, park the vehicle outside
where there is a clear view of the southern sky.
5. Look at the audio unit display, and turn the TUNE
knob.
• If you can tune to channels
000
,
001
,
007
,
009
,
047
,
122
,
174
, and
247
, the dealer demo service
is activated. Tune to channel
001
, and leave the
radio on for 7 minutes to refresh the dealer demo
service. No further action is needed.
• If you cannot tune to channels
000
,
001
,
007
,
009
,
047
,
122
,
174
, and
247
, the dealer demo
service is not yet activated, and an activation
refresh needs to be done. Go to step 6.
2 CLIP NUTS
MOUNTING
BOLTS
HOLDER
