Page
8
of
13
8.
Clean the Rear License Plate Area, and Install the Mounting Hardware
Remove the masking tape that covers the two bolt holes. Using 3M General Purpose Adhesive Cleaner
(3M #051135-08984) and a clean shop towel, carefully remove any tape residue. Then, install the two long bolts and
two self-tapping screws as shown.
Vehicle Exterior (Vehicle Lowered to Ground)
9.
Set the Tire Pressures
To prevent flat spots during vehicle shipping and storage, the tires are inflated to over
40 psi
. Adjust the tire pressures
to the cold inflation values listed on the driver’s doorjamb label. If you are in a cold climate region, make sure the tires
are at the same temperature as the outside air before adjusting the pressures; otherwise, the Low Tire Pressure/TPMS
indicator may come on in cold weather.
NOTE: There is no spare tire. This vehicle comes with a tire repair kit that is stored under the trunk lining. An optional
spare tire can be ordered separately.
10.
Initialize the TPMS
If the Low Tire Pressure/TPMS indicator stays on with the ignition turned to ON, do this to initialize the system:
1. Start the engine, then turn it off.
2. Wait
25 seconds
.
3. Repeat steps 1 and 2 three times.
4. Check the TPMS message in the MID; the tire pressure readings should be normal. If they are abnormally high,
check for DTCs with the i-HDS.
