uu
Locking and Unlocking the Doors
u
Locking/Unlocking the Doors from the Outside
164
Co
ntrols
To temporarily deactivate the function:
1.
Set the power mode to OFF.
2.
Open the driver’s door.
3.
Using the master door lock switch, operate
the lock as follows:
Lock
Unlock
Lock
Unlock.
u
The beeper sounds, and the function is
deactivated.
To restore the function:
•
Set the power mode to ON.
•
Lock the vehicle without using the auto lock
function.
•
With the keyless remote on you, move out
of the auto lock function operation range.
•
Open any door.
1
Locking the doors and tailgate (Walk away auto lock
You must wait until the power tailgate fully closes
before the auto lock function will be activated.
The auto lock function does not operate when any of
the following conditions are met.
•
The keyless remote is inside the vehicle.
•
A door or the hood is not closed.
•
The power mode is set to any mode other than
OFF.
•
The keyless remote is not located within a radius of
about 5 feet (1.5 m) from the vehicle when you get
out of the vehicle and close the doors.
Auto lock function operation stop beeper
After the auto lock function has been activated, the
auto lock operation stop beeper sounds for
approximately two seconds in the following cases.
•
The keyless remote is put inside the vehicle through
a window.
•
You are located too close to the vehicle.
•
The keyless remote is put inside the tailgate.
If the warning beeper sounds, check that you are
carrying the keyless remote. Then, open/close a door
and confirm the auto lock activation beeper sounds
once.
23 ACURA RDX-31TJB6400.book 164 ページ ２０２２年８月４日 木曜日 午後１時５１分
Summary of Contents for RDX 2023
Page 1: ...2023 RDX Owner s Manual ...
