uu
If a Tire Goes Flat
u
Temporarily Repairing a Flat Tire
*
526
Han
d
lin
g the U
n
expected
4.
Plug in the compressor to the accessory
power socket.
u
Be careful not to pinch the cord in a
door or window.
u
Do not plug any other electronic
devices into other accessory power
sockets.
2
Accessory Power Sockets
P. 207
5.
Start the engine.
u
Keep the engine running while injecting
sealant and air.
2
Carbon Monoxide Gas
P. 71
6.
Turn the selector switch to
REPAIR
.
1
Injecting Sealant and Air
NOTICE
Do not operate the temporary tire repair kit compressor
for more than 15 minutes. The compressor can
overheat and become permanently damaged.
There are three accessory power sockets:
•
In the console compartment
•
In the front of the center pocket
•
In the left side panel in the cargo area
2
Accessory Power Sockets
P. 207
Until the sealant injection is complete, the pressure
shown on the pressure gauge will appear higher than
actual. After the sealant injection is complete the
pressure will drop and then begin to rise again as the
tire is inflated with air. This is normal. To accurately
measure the air pressure using the gauge, turn the air
compressor off only after the sealant injection is
complete.
3
WARNING
Running the engine with the vehicle in an
enclosed or even partly enclosed area can
cause a rapid build-up of toxic carbon
monoxide.
Breathing this colorless, odorless gas can
cause unconsciousness and even death.
Only run the engine to power the air
compressor with the vehicle outdoors.
REPAIR
17 ACURA MDX-31TZ56300.book 526 ページ 2016年10月25日 火曜日 午後2時27分
Summary of Contents for MDX2017
Page 227: ...226 17 ACURA MDX 31TZ56300 book 226...
Page 347: ...346 17 ACURA MDX 31TZ56300 book 346...
Page 461: ...460 17 ACURA MDX 31TZ56300 book 460...
Page 513: ...512 17 ACURA MDX 31TZ56300 book 512...