15
Moisten the transmitter electrodes
: apply a
small drop of water on each of the two contact
areas (Fig.3).
Fig. 3
If you feel comfortable replacing your own
batteries, be careful to notice how the old
battery comes out and the proper positioning
of the hold-down contacts before removing it.
Also, be careful to line up the o-ring gasket
properly before replacing the battery door
cover. To help insure battery water resistance,
it’s a good idea to smear a small drop of
siliconelubricant spray on the rubber o-ring.
.
General Precautions
Do not operate buttons under water.
Although
your monitor is water resistant, be sure that
you do not operate its buttons under water as
pressure can cause them to leak.
Dry off transmitter after use.
The transmitter
will automatically shut itself off once you have
disconnected it from your chest. However, it is
important to thoroughly dry it off after every
use, since moisture in the electrodes can cause
it to remain on longer.
Electrode precautions.
Be sure not to excessively
twist or bend the electrode portions of the belt
(never bend backwards), especially when storing
it. This can permanently damage their conductivity
and cause mechanical damage to the internal
circuit.
Globe Reset
. If your monitor should ever get
stuck or act erratically due to dropping it, static
shock or some other unforeseen reason, this
feature will allow you to reset the unit and
return all settings back to their internal defaults.
To perform this function press and hold all
buttons at once. Caution: THIS WILL CLEAR
EVERYTHING! Including all of your personal
settings.
6
2. Attach your wrist monitor. The watch does
not have to be attached to your wrist to register
your heart rate, but it should be within 3 feet
of your chest.
3. Press the
MODE/SET
button to start the Heart
Rate reading.
Buttons and Functions
•
MODE/SET
button
- Press momentarily to
change modes.
- Press and hold to enter
setting modes.
• /
(
LIGHT /ALARM)
button
- Press momentarily to
activate the night light for 3 seconds.
- Press and hold for 3 seconds to toggle alarm
ON/OFF for the current display mode.
•
STR/STOP/RESET
button
- Press momentarily to start or stop the stopwatch.
- Press and hold to reset.
Note:
All buttons produce one short beep when
pressed. Press and hold operation also produces
another beep.
Electrode
MODE/
SET
LIGHT/
ALARM
START/
STOP/
RESET
TZ
