background image

The main unit is capable of displaying some values in an alternate scale mode.
To switch between modes, press the “SCALE” button.

NOTE: The “WIND SPEED” history mode chart will not change to “kph” scale, it will 
remain displaying “mph” data.

Main Unit : Scale Selection

The wireless sensor will soon send a signal to the main unit and the two units will be 
synchronized. It may take a few minutes for synchronization to be complete. If both 
or one of the units appear to be functioning improperly, refer to the troubleshooting 
section in this manual.

Setup is Now Complete

After installing batteries, it is recommended that you set the clock and calendar 
initially. After the atomic clock signal is acquired, which may take up to 24 hours, the 
clock accuracy and daylight saving time changes will be automatically maintained.

To 

set the clock and other preferences

, press AND HOLD the “SET” button for 5 

seconds to enter into SET MODE. Once in set mode, the preference you are currently 
setting will blink on the display. 

To 

adjust

 

the currently selected (flashing) preference item, press the “+” button (press 

and HOLD to fast adjust).

To 

save

 your adjustments, press the “SET” button again to move on to adjusting the 

next preference. The preference set order is as follows:

TIME ZONE 

(PST MST CST EST)

DST 

(Daylight Saving Time ON OR OFF)

CLOCK HOUR
CLOCK MINUTE
YEAR
CALENDAR MONTH
CALENDAR YEAR

You will automatically exit SET MODE if no buttons are depressed for 30 seconds.  You 
may enter basic setup mode again at any time by pressing AND HOLDING the “SET” 
button.  

Main Unit : Basic Setup

- 7 -

- 6 -

SCALE MODE 1 - U.S. Standard
Temperature - ºF (fahrenheit)
Barometric Pressure- inHg (inches of mercury)
Wind Speed/Peak/Average- mph (miles per hour)

SCALE MODE 2 - Imperial Standard
Temperature - ºC (Celsius)
Barometric Pressure- hPa (Hectopascal)
Wind Speed/Peak/Average- kph (kilometers per hour)

SEC TION 3 • OPERATION

B

14 Day Learning Mode

This weather station has a patented 
“fourteen day learning mode” calibration 
process. During this learning mode the 
weather station will make altitude 
calculations that may affect the accuracy 
of the forecast. Once the 14 day learning 
mode process is complete, the learning 
mode icon will disappear and the 
weather forecast should be ready for 
superior operation.

A

A

B

Future Forecast Icon

The future forecast feature automatically gives you the predicted weather forecast 
icon for the next 12 to 24 hours based on an advanced algorithm that analyzes 
barometric pressure changes and temperature. This weather forecaster will provide 
the most accurate forecast that a single station instrument can provide.

HEAVY STORM

heavy stormy

 weather

conditions are

forecasted

when flashing

stormy conditions

are forecasted

next 12-24 hours

mostly cloudy

 conditions

are forecasted

next 12-24 hours

partly cloudy

 conditions

are forecasted

next 12-24 hours

mostly sunny

 conditions

are forecasted

next 12-24 hours

STORMY

MOSTLY CLOUDY

PARTLY CLOUDY

MOSTLY SUNNY

rain or snow

rain or snow

Summary of Contents for 00634








Reviews: