Dehumidifying operation
MODE
UP/DOWN
ON/OFF
Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the
button to select DRY mode.
2. Press the
buttons to set the
desired temperature.
3. Press the
button to start the air
conditioner.
The temperature
can be set within a range of 17 C~ 30 C
in 1 C increments.
O
O
O
In the Dehumidifying mode, you can not switch the
fan speed. It has already been automatically controlled.
NOTE
Adjusting air flow direction
Timer operation
Press the TIMER ON button can set the auto-on
time of the unit. Press the TIMER OFF button
can set the auto-off time of the unit.
1. Press the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-on
setting time and the signal "H" will be shown on
the LCD display area. Now it is ready to reset
the Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button,
the time increases by half an hour between 0
and 10 hours and by one hour between 10 and
24 hours.
3. After setting the TIMER ON ,there will be a one
second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "H" will disappear and the set temperature
will re-appear and the TIMER ON will appear on the
LCD display window.
To set the Auto-on time.
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
controller shows TIMER OFF, the last Auto-off
setting time and the signal "H" will be shown on
the LCD display area. Now it is ready to reset
the Auto-off time to stop the operation.
2. Push the TIMER OFF button again to set
desired Auto-off time. Each time you press the
button, the time increases by half an hour
between 0 and 10 hours and by one hour
between 10 and 24 hours.
3. After setting the TIMER OFF ,there will be a
one second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "H" will disappear and the set temperature
will re-appear and the TIMER ON will appear on the
1
2
LCD display window.
Use the SWING and DIRECT buttons to adjust
the desired airflow direction.
1. When press the DIRECT button, the horizontal
louvre changes 6º degree in angle for each press.
2. When press the SWING button, the louvre will
automatically swing up and down.
When the horizontal louvre swing or move
to a position which would affect the cooling
or heating effect of the air conditioner, it
would automatically change the swing /
moving direction.
NOTE:
3
1
2
MODE
MODE
SWING
SWING
TEMP
TEMP
SHORTCUT
FAN
SPEED
FAN
SPEED
TIMER
OFF
TIMER
OFF
RESET
RES ET
LOCK
LOC K
LED
FOLLOW ME
LED
FOLLOW ME
TIMER
ON
TIMER
ON
TURBO
SEL FCLEAN
TURBO
SELF CLEAN
DIRECT
DIRECT
SLEEP
SLEEP
O N / O F F
O N / O F F
