Operation Manual
LM7/24-2 Wall Controller
Operation Manual LM7-2 / LM24-2 Wall Controller
Document No. 0525-079
Ver. 1 190821
Page 18
Re-activating an Individual Event
1.
Repeat steps 1 and 2 as above.
2. Press the
Button until the time re-appears.
09.07. Repeating a Day’s Events and Times
This feature allows you to automatically repeat the previous days, events, and times, into the succeeding days.
1.
Proceed to the day you wish to copy the programmed events and times. See Programming the Events
from previous page.
2. Press the
PROG
Button until you reach
the succeeding day’s, Event 1, On time is displayed.
SET
,
EVENT
1
,
TIME CLOCK
and
ON
will be illuminated in the screen.
3. Press the
REPEAT
Button. You have now copied the previous day’s events into the current day displayed.
4. Repeat Steps 2 and 3 above for the remaining days where you wish to repeat the programmed events and
times.
10. Zone Controller Functions
Turning Zones ON and OFF
1. Press the
Zone
Button to turn zones On and Off.
2. Lights are illuminated when zone is turned On.
NOTE
• By default, the minimum of one zone must be left On. This is controlled automatically by the wall control and will not
allow you to turn off the last zone operating. However, it is possible to turn Off all zones in some models. Contact
your installer for more details.
• Switching the last zone off will cause the controller to divert to Zone 1 automatically.
Room Temperature Display
1. Press the
or
Buttons and the room temperature will be displayed for 3 seconds.
NOTE
• The room temperature displayed can be the temperature at the wall controls or remote wall sensors or a
combination of both, depending on which zones are turned on.
