31
HONDA
SPECIAL NOTE:
Vehicles With Electronically Controlled Automatic Transaxles
• After engine control system repair,
clear the automatic transaxle
computer’s memory by removing the
appropriate fuse for 15 seconds.
• Test drive the vehicle, then re-check
the engine control system for trouble
codes. In many cases, once the
engine control system failure is
repaired, the transaxle trouble code
will also disappear.
• If the transaxle trouble code is not
eliminated, then proceed with a self-
diagnostic check on the automatic
transaxle as outlined in the vehicle
service manual.
• Some vehicles have computer
controlled automatic transaxles
(transmissions).
• Typically these transmissions are self-
diagnosing, similar to the engine
control systems covered in this
section.
• Note that certain engine control
system failures may also cause the
“S”, “D”, or “D
4
” transmission indicator
lamp to flash along with the “CHECK”
Engine lamp. Should this happen
during the trouble code reading
procedures described later, repair the
engine control system trouble codes
first.
Summary of Contents for Code Scanner CP9025
Page 49: ...49 NISSAN...
