3
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
•
UV Light in operation; disconnect unit from power supply before
servicing; failure to follow warnings may result in severe eye damage
and electrical shock
•
To prevent damage to the unit, operating environment temperature
must never exceed 200
o
F (93
o
C)
•
DO NOT use this unit with an extension cord
•
To reduce the risk of electric shock, this equipment may have a
grounding type plug that has a third (grounding) pin; this plug will
only fit into a grounding type power outlet; if the plug does not fit
into the outlet, contact qualified personnel to install the proper
outlet; DO NOT alter the plug in any way
•
This unit is equipped with a universal ballast that operates at
nominal voltages between 100 and 240 VAC, 50/60 Hz
•
To Reduce the Risk of Electric Shock – DO NOT use in wet or damp
locations; this equipment emits UV-C radiation; DO NOT locate
equipment in any location allowing direct line-of-sight to vents,
returns, or other duct openings
•
DO NOT connect this unit to any voltage source above 32 volts;
doing so will cause damage to the unit
WARNING
Location for Protective Earth Line.
CAUTION
• Wiring and installation of this unit must be done by a licensed HVAC
contractor or electrician; failure to do so will void warranty of the
product
• When the unit is installed in a roof mounted HVAC system, the unit
must be protected from the elements
Read this manual in its entirety before using your ActivePure
®
Induct Guardian I.
Keep out of the reach of children.
•
Live voltage may be present
•
Power Connection Requirements:
This device is designed to operate using a 24 VAC, 40Va
transformer . Transformers supplied with a straight cooling or HVAC system may be used to
power the device but must be verified it’s capable of handling the additional device load before
installation . If the system transformer is not capable of handing the extra load, a separate 24 VAC,
40Va transformer MUST be used . Do not connect the device to any power source with a voltage
less than 22 VAC and a maximum of 32 VAC . Doing so will cause damage to the device
•
Disconnect power at the breaker or fuse panel before servicing unit; always follow OSHA lockout
procedures to prevent accidental exposure to electrical energy
•
If installed near a furnace or where emergency heat coils could raise the temperature inside the
plenum, cycle the AC unit through three full heating cycles assuring that the temperature never
exceeds 200 °F (93 ° C) .The ActivePure
®
Cell must not exceed 200 °F (93 °C)
•
If the unit is hard wired, be sure the power to the unit is off; always follow OHSA electrical lockout
safety requirements to prevent accidental release of energy during service or maintenance
activities
•
Never attempt to check operation of the ActivePure
®
Cell(s) by direct observation; severe eye
damage can result; use the indicator lamps on the bottom of the ballast on