G. nstall i joystick by installing the i mounting bracket to the top of the ErgoReJoy platform using the two
holes shown in figure . Mount i joystick to i mounting plate. Position housing of joystick at least
”
from the two ” balls on top of the ErgoReJoy joystick platform and use the M screws to install the joystick
. nstall Shark joystick by adding black spacer block under joystick and installing both with two long M- screws
through holes
” apart (refer to figure ).
. Coil the joystick cable tightly and secure it under the platform using the cable holders
attached. eave approximately ” of cable to connect to the joystick connection harness in
the next step (refer to figure ).
. nstall joystick specific harnesses to joystick and connect to mini-mast harness ( 0
).
se the cable holders under the platform if needed to secure excess cable length. The
mini-mast connection harnesses for each joystick are as follows
A. R et fixed cable joysticks connect to R ET ” Extension harness. Connect ” ext. to
0 0 mast connection harness. Connect 0 0 to 0
mini-mast harness
. R et removable harness - replace with 0
and connect it to 0
mini
mast harness
C. - ogic , E (no mast harness required)
D. - ogic ( 0
)
E. R ( 0 0 )
F. i (
)
G. Shark ( 0 0 )
. nstall Active Controls extension harness ( 0
) to each socket(s) harness ( 0
).
A. Assessment kits include two or more sockets and require attaching each extension harness ( 0
) to the
multiple socket harness ( 0 0).
. For single socket installations, install ( 0
) to socket harness ( 0
)
. Attach joystick connection harness and extension harness into the controller’s joystick port.
A. Connect Active Controls joystick specific controller harness to the 0 0 (for two or more socket configuration)
or 0
extension harness (for single socket configuration). The specific controller connection harnesses are as
follows
. R et ( 0 0 )
. - ogic , E
. - ogic ( 0
)
. R ( 0 0 )
. i (
)
. Shark ( 0 0 )
. Connect the joystick’s controller connection harness into the controller port where the
joystick was originally connected.
. Position joystick and
ErgoReJoy platform at the end of armrest in the standard joystick
location (refer to photo taken in Step III above).
A. Confirm the receiver sockets are located at the lowest socket height and secured in place
by the adjustable handle (see figure )
figure 5
figure 4
