4
Princess Birth Pool
Pool
- measure 1020 mm from the centre point on the wall and mark this
as the point to locate the bracket so that the long flat piece is projecting away from the wall and
raised short section faces forward into the room.
Secure the bracket to the floor using suitable hardware.
Step 3: Place the birth pool at least 60 mm away from the rear wall to avoid resting on the now
secure bracket.
Push the birth pool towards the wall so that the flange of the pool slides under the bracket.
This secures the front of the pool to the floor
Step 4: The 2
nd
fixing bracket should be located on the flange below the access panel as
indicated in the images above.
The long flat piece should be fixed to the floor with suitable hardware so that the short section
is holding the flange securely to the floor.
Step 5: Seal the water birth pool to the floor and wall using a suitable sealant to prevent
ingress of water and dirt.
