2
Fitting
All feet MUST be in solid contact with the floor. If the floor is not level or smooth be sure to
adjust the feet or level the floor so that all of the feet are in firm contact with the floor and there
is no rocking or movement.
The bottom flange of the outer panel should be in contact with the floor but IS NOT the primary
support structure of the pool and must not bear the full weight of the filled birth pool.
The water birth pool is supplied with 2 x 100 mm x 30 mm brackets to fix it to the floor. You’ll
find the brackets taped to the pool just inside the access panel that can be opened with a 10
mm Allen Key.
It is essential these brackets are securely fixed to the floor with suitable hardware to immobilise
the pool and prevent it from moving when empty.
Failure to fix the pool to the floor with the brackets will VOID the guarantee.
Zinc Plated Fixing Bracket
Step 1: Mark the central position of the water birth pool on the IPS Panel or wall that it is being
fitted on.
Step 2:
Active Birth Pool
- measure 1220 mm from the centre point on the wall and mark this as the
point to locate the bracket so that the long flat piece is projecting away from the wall and raised
short section faces forward into the room.
