USAGE CAUTION
BEFORE OPERATION
• Check to ensure that your electric service's voltage and frequency conform with those on the
pump's nameplate.
• The pump should be powered through a Ground Fault Circuit Interrupter (GFCI) outlet.
• Never lift, lower, or carry the pump by the power cord.
• Always unplug or switch off the mains before doing any maintenance or placing your hands in
the water to which this pump is connected.
• Do not attempt to lubricate the pump or operate it without water. It will damage the pump.
• Do not use the pump in water with a temperature higher than 104°F (40°C), as it will
significantly shorten the life of the pump.
• The pump should always be unplugged before examination.
THE PUMP SHOULD NOT BE USED IF:
• Its power supply cord or other important parts are damaged in any way
• Its plug or the power outlet are wet
• Its output appears to be reduced or restricted
• Some part of the pump is broken or cracked and water is leaking into the pump chassis
• Anything abnormal with it occurs
DURING OPERATION
• Unplug the pump immediately to prevent the motor from being burned out if the motor
becomes overloaded due to being clogged with foreign matter.
• Do not move or reposition the pump while it is powered and running.
• Do not allow the power cord to be kinked.
AFTER OPERATION
1. If freezing temperatures are predicted, remove the pump from the water and dry out the
impeller chamber completely. If water trapped inside the impeller chamber is allowed to freeze,
it may damage the pump.
2. If the pump is allowed to remain submerged in water for a long period of time without
operation, it might rust the pump, so it is best to remove it and dry it out if it will not be
operated for any length of time. Also, organic residue may accumulate inside the pump, which
can reduce its performance. If this happens, run the pump in clean water for a while to remove
most organic matter from it, then store it after draining and drying.
5
