ASSEMBLY INSTRUCTIONS
ASSEMBLY
1. Unscrew the locking lever (#21) from the
bottom of the outer stand pole (#17).
2. Turn the outer stand pole (#17) upside
down. Now take the fan base (#18), flip it
upside down and slide the base into the
center of the outer stand pole. Place the
black weight (#19) onto the base (#18),
followed by the washer (#20).
3. Insert the threaded end of the locking lever
into the hole of the washer and through the
base into the bottom of the stand pole. Turn
the locking lever clockwise to secure and
tighten the base to the stand pole.
4. Carefully turn the base over with the stand
pole connected and set it on the floor.
5. The inner stand pole (#15) comes with a
thumbscrew (#24) preinstalled. Remove the
thumbscrew and set it aside.
6. The fan motor comes with an attached neck
adaptor (#23). Notice this adaptor has a
hole drilled in it near the bottom. Slide the
fan neck adaptor atop the inner stand pole.
Align the hole on the neck adaptor atop the
stand pole.
5