14
MOVING THE POMMEL
The pommel can be taken off the seat to assist with
putting the child in the wheelchair. This can be done by
loosening the screw fitting in the centre (on the
underneath of the chair) at the front. When the screw is
loosened, the pommel bar will slide out of the bar
attached to the base, and the pommel will come off the
chair. This can be replaced by sliding back into the
holder and the screw tightened.
Ensure the pommel is firmly secured before setting off.
THE SINGLE FOOTREST
The angle of the footrest can be adjusted by using
the lever handle on the bar underneath. When this
lever handle is unwound, the footrest can be
tipped back or forward to re-position it. When the
preferred position is obtained the lever handle can
be tightened. To re-position the handle, the centre
button can be pushed in and the handle moved to
a different position.
TO LOWER THE FOOTREST
If the footrest is too high or too low for the child this can
be adjusted by loosening the bolt on the end of the bar
which is attached inside the leg-rest tubes. Then the
bar can be lowered or raised to suit the child. When re-
positioned, the bolt should be tightened and the footrest
is ready to use.
TO REPOSITION THE FOOTREST
There is also a facility to reposition the entire footrest away
from, or in towards the wheelchair. This is achieved by
using the screw fitting on the side of the chair at the very
front, which holds the bar attaching the footrest to the
base. When this screw is loosened the bar can be pulled
or pushed to a new position, and then the screw should be
tightened. The footplate can be removed when stowing
the wheelchair into a vehicle.
Summary of Contents for Corgi Power Hi-Lo
