35
Plug-N-Play settings. These settings can be found within the “Advanced,” “PNP/
PCI Configuration,” or “Plug-and-Play Configuration” sections depending on the
BIOS Manufacturer. Next, verify that at least two IRQs have been set so that the PCI
bus has access to them (some BIOS don’t allow individual selection of interrupts to
ISA, Plug-N-Play, or PCI). These settings can be called ICU, ICU/PCI, PCI, or
PNP depending on your BIOS version and manufacturer. Do not set all the inter-
rupts to “ISA” only or to “Legacy ISA”. Pay attention to the IRQ usage of the other
peripherals in your system. Do not reassign an interrupt that is already in use by an
ISA card to the PCI bus.
Common Problems
No Dialtone Error
Make sure you have connected the phone cable into the right connector on the back
of the modem. See Figure 7.
You may have too many devices connected to the phone line. Remove all other equip-
ment.
Your modem may not recognize overseas dialtone. Use the AT command
ATX0
to
have the modem ignore (not look for) the dialtone before dialing. (See Appendix A
for information on how to use AT commands.)
Communications Software Does Not Work
Some communications software packages need to be configured to the same COM
port and or IRQ as the modem. See the “Installing the Modem” for information on
how you determine your COM Port and IRQ number.
Does the communications software support this modem? See the
Installing and Con-
figuring Communications Software
section.
If you are using a different software from the one supplied with the modem (some
models of this modem may be shipped without communications software), try in-
stalling the supplied software and verify its functionality with the modem.
Nothing Appears On The Screen When I Type
Issue the AT command
ATE1
to the modem to enable command echo. This will let
you see what you type.
Summary of Contents for 56K PCI Pro
Page 1: ...56K V 90 PCI Voice Fax Windows Modem...
Page 81: ...80...
