14
S001964 10ft Trampoline
Assembly Instructions (cont)
Step 4
Attach 1 x Safety Instruction Placard (7) to the trampoline frame in a position that is easily visible.
Thread the included cable tie through the hole in the Safety Instruction Placard (7) and wrap it around
the frame. Secure this into place by placing the flat end of the cable tie through the gap at the other
end and pulling the flat end through until it is fitted tightly around the frame.
Lay the Frame Pad (2) over the trampoline so that the springs and frame are completely covered.
Please ensure that the small gaps in the Frame Pad (2) are aligned with the T-Joints (9) so the top of the
T-Joints (9) fit through the gap.
To secure the Frame Pad (2) to the trampoline, take the hook attached to the base of the Frame Pad (2)
and clip this to a v-ring that is two or three springs to the left of the strap.
Warning: Do not position your face close to the strap as if you let go it can rebound at high speed
causing injury.
Repeat this for all hooks on the Frame Pad (2). There should be a few remaining pairs of straps on the
Frame Pad (2), take each pair and wrap each side around the outside of the stitched material holding
the v-rings to the Mat (1). Tie a knot using a pair of the straps under the v-ring to finish securing the
Frame Pad (2) in place.
2
