13
S001964 10ft Trampoline
Assembly Instructions (cont)
Step 3
Lay the Mat (1) out flat on the floor inside of the completed trampoline frame. Ensure that the side of
the Mat (1) with double stitching is facing downward, the warning label stitched into the mat should be
located on the top side of the mat.
To begin attaching the Mat (1) to the frame take 2 x Springs (6) and place these at opposite ends of
the Mat (1). Place the end of the Spring (6) with the narrow opening over the metal v-rings at the edge
of the mat and insert the opposite end of the Spring (6) with the wide opening into the groove on the
Top Rail (3) using the Spring Hook (8). Repeat this for the other Spring (6) to even out the tension in the
mat.
Take another 2 x Springs (6) and repeat the above instructions so there are now 4 x Springs (6)
connecting the Mat (1) to the Top Rails (3) at points ¼ the way around the frame. Use the remaining
Springs (6) to connect the Mat (1) to the Top Rails (3) securing it into position.
Note: It is recommended that you connect a handful of Springs (6) on one side of the frame and
then connect the same number of Springs (6) to the opposite side of the frame, this will even out
the tension on the Springs (6) from the Mat (1) and make it easier to connect the last couple of
springs.
1
6
8
Wide opening
Narrow opening
