To activate using remote control: press [ ARM ] key once.
STAY ARM
This is for partial arming of the alarm system when there are people at home, only some of the
selected sensors are activated and could be triggered by events.
In a STAY ARM status, the panel [ARM ] light is flashing.
To activate using remote control: press [STAY] key once.
DISARM
All sensors are deactivated and will not be respond to any events.
In a DISARM status, the panel [ ARM ] light is off
To activate using remote control: press [DISARM] key once.
EMERGENCY
When an emergency occurs, press emergency button on the remote or the * button on panel to
activate alarm.
2.2
System Setup
2.2.1 Panel Setup
Alarm panel should be installed at a central location with best transmission to all the
wireless sensors and accessories. Keep the panel well away from large metal objects or
household appliances with high-frequency interference, and avoid barriers such as
concrete walls with metal frame inside and fire doors.
function
Indications
Description
Built-in speaker
short "beep" once
KeyTip
"beep", "beep" two short
tones
Exit configuration or learnt
succeed
"beep", "beep", "beep" three
short tones
Error indication
Voice prompt
The prompt voice of the
function and status
ARM LED
Light up
Alarm panel at ARM state
Rapid flashes
Alarm panel at STAY ARM
state
Flash slowly
Alarm panel at delay ARM or
recording state
Off
Alarm panel at DISARM state
Defense zone indicating
light(1~6)
Light up
A(1~6) zone alarm
One LED flashing
This zone enter delay alarm
state
All flashing
Unloaded SIM card or
loaded wrong
GSM Signal indicator
Flash one time for 1s
GSM
Signal weak or
unloaded SIM card
