Hardware Manual
3.
Drill the screw holes. Depending on the material of the surface where the camera will be
installed, it may be necessary to drill the three (3) screw holes and use the supplied screw
tox.
Step 2: Route the Cables
Determine whether the cable will pass through a hole on the surface or be routed along the
surface:
If the cable will pass through a hole on the surface
:
1.
Drill the hole for the cable on the surface.
2.
Route the cable from the network side and connect it to the Ethernet port of the camera.
NOTE:
If the camera will be installed outdoors or in places wherein environmental factors
change drastically, make sure to waterproof the cable connection; see
on page 14 for instructions.
3.
Push the cable through the hole on the surface.
4.
Skip to
If the cable will be routed along the surface,
route the cable through the gap on the side of
the camera bracket.
