This insTallaTiOn guide cOvers The fOllOwing prOducTs:
acTpro elock
ACTpro eLock 125Khz RFID
acTpro elock K
ACTpro eLock 125Khz RFID with external Key Override
acTpro elock K2
ACTpro eLock 125Khz RFID with internal & external Key Override
acTpro elock Mf
ACTpro eLock MIFARE Classic/DESFire EV1
acTpro elock MfK
ACTpro eLock MIFARE Classic/DESFire EV1 with external Key Override
acTpro elock MfK2
ACTpro eLock MIFARE Classic/DESFire EV1 with internal & external Key Override
carTOn cOnTenTs:
1.
User Installation Manual (this document)
2.
Front and Back escutcheons including 8mm spindle
3.
Door drill template
4.
2 x Door handles and handle grub screws
5.
2 x 35mm and 2 x 45mm M5 Mounting screws
6.
2 x M3 6mm back cover fixing screws.
7.
Screw cap cover
8.
2.5mm Hex Key
9.
CR123A Battery
TOOls reQuired:
1.
Power drill
2.
Drill bits 16mm and 8mm
3.
Pozi screwdriver
4.
Hex key 2.5mm (Supplied)
5.
Thread locking adhesive
(ACT recommends Loctite 242).
The
ACTpro eLock
can be used on most mortise locks with 8mm spindle and is compatible with
door thicknesses from 36mm to 60mm.
The ACTpro eLock K and MFK versions support euro profile cylinder locks that are positioned 72mm
from the spindle centre; and has key override cut-out on the entry escutcheon only.
The ACTpro eLock K2 and MFK2 versions of the eLock support euro profile cylinder locks that are
positioned 72mm from the spindle centre; and has key override cut-out on the entry and exit escutcheon.
wireless cOMMunicaTiOns:
The ACTpro eLock and the eLock Hub communicate
wirelessly, operating at 868.8MHz. The communications
between the eLock and hub are secured using 128 bit
AES encryption.
The range of the wireless signal is dependent on the
characteristics of the building and it is recommended to
complete a site survey to determine the best location of
ACTpro eLock hubs.
