ACS ACR101, Reference Manual

Page: 13 / 19

7.1.1.7. PC_to_RDR_SetParameters
Set slot parameters.
Offset Field Size Value Description
0
bMessageType
1
61h
1 dwLength 4 Size of extra bytes of this message
5 bSlot 1
Identifies the slot number for this
command
6 bSeq 1 Sequence number for command
7 bProtocolNum 1
Specifies what protocol data structure
follows.
00h
= Structure for protocol T=0
01h
= Structure for protocol T=1
The following values are reserved for
future use.
80h
= Structure for 2-wire protocol
81h
= Structure for 3-wire protocol
82h
= Structure for I2C protocol
8
abRFU
2 Reserved for future use
10
abProtocolData
Structure
Byte
array
Protocol Data Structure
Protocol Data Structure for Protocol T=0 (
dwLength
=
00000005h
)
Offset Field Size Value Description
10
bmFindexDindex
1
B7-4 – FI – Index into the table 7 in
ISO/IEC 7816-3:1997 selecting a
clock rate conversion factor
B3-0 – DI - Index into the table 8 in
ISO/IEC 7816-3:1997 selecting a
baud rate conversion factor
11 bmTCCKST0 1
B0 –
0b
, B7-2 –
000000b
B1 – Convention used (b1=0 for
direct, b1=1 for inverse) Note: The
CCID ignores this bit.
12
bGuardTimeT0
1
Extra Guardtime between two
characters. Add 0 to 254 etu to the
normal guardtime of 12 etu.
FFh
is
the same as
00h
.
13
bWaitingIntegerT0
1 WI for T=0 used to define WWT
14 bClockStop 1
ICC Clock Stop Support
0
0
h = Stopping the Clock is not
allowed
01h
= Stop with Clock signal Low
02h
= Stop with Clock signal High
03h
= Stop with Clock either High or
Low
Document Title Here
Document Title Here
Document Title Here
ACR101 PC/SC Memory Card Access
Version 1.0
Page 13 of 19
info@acs.com.hk
www.acs.com.hk