ACS A1208, Operation Manual

Page: 23 / 48

Ultrasonic thickness gauge A1208
Operation Manual
23
ACOUSTIC
CONTROL
SYSTEMS
2
Figure 22
Key Intended use
Moving in the table of characters
Select a character for editing
Replace the active character with a character from the table
After the replacement, the next character becomes active
F1 (Save) Exit and save the changes
F2 (XXX)
Changing the characters in the letter table where, ХХХ:
абв are russian small letters (for russian interface only)
АБВ are russian capital letters
abc are english small letters
ABC are english capital letters
F3 (Exit) Exit the editing without saving changes
Table 6
Editing the information on a material.
Active keys:
F1 (Edit) go to the information editing of the selected material. The process of editing is similar to the creation of a new
material described above.
F2 (Delete) delete the material from the device memory.
F3 (Exit) return to the main window of the SETUP mode.
select a material for further work and return to the main window of the SETUP mode.
When you exit the library, the device saves the last active line and sets it when you return to the library. When the
device is switched off, the information on the active line is reset.