3
Day Setting
Set hour wheel (center wheel) to 4 (4 AM) by moving the hour wheel toward the
front of the unit and align 4 to Red Notch (Figure 2)
Take a test print to check the day printed
Adjust the day wheel by moving wheel toward the front of the unit
Take a test print to confirm correct day is printing
(Figure 2)
Hour Setting
Note: PM Hours are denoted by an underscore (eg. 12, 5, 3)
Adjust hour wheel by moving the center wheel toward the front of the unit
Align the correct hour with the Red Notch
Minute Setting
Hold down the minute lever (Figure 1)
Adjust the minute wheel to
One Minute Before
the current time by moving the
wheel toward the front of the unit and aligning the Red Notch
Release the minute lever
The correct minute should now line up with the Red Notch
Completion
Take test print and verify correct time
Confirm ribbon is properly seated as shown in (Figure 3)
Plug in PD100
Replace cover
