Version 1.3
Operation Manual, Nimbie NB11
© 2010, Acronova Technology, Inc.
17
downward.
2) Run the LightScribe-enabled application software and follow the
instructions to LightScribe label the discs.
Turning Nimbie On
Make sure that Nimbie’s device driver has been successfully installed
as previously explained.
Follow the steps below to get your Nimbie ready:
1) Connect the power cord to Nimbie and a wall outlet.
2) Turn Nimbie’s power switch to the On position.
3) Connect the USB cable to both Nimbie and your PC.
Nimbie will enter the initialization process and will remove any discs
inside the optical recorder. Be patient until the initialization process
has completed.
When initialization is complete, you will see the “ready” indicator light up
signaling that Nimbie is ready for a disc operation
Turning Nimbie Off
To turn Nimbie off, turn the power switch to the Off position. In case
there is a session underway, abort or wait until it has completed.
Although it is fine to leave the power cord plugged in, it is
recommended that you unplug the cord for increased safety when
Nimbie is not used for extended periods of time.
