ACEX4041 COM Express Type 10
AcroPack Carrier Board
- 39 -
ACROPACK MODULE INSTALLATION
1.)
Power should be removed from the carrier board when installing
AcroPack modules, cables, termination panels, and field wiring. To install,
first insert the edge of the AcroPack module into the carrier connector at
an angle like that shown below.
2.)
Next, using a rocking motion while gently applying force to keep the edge
of the board against the back of the carrier connector, position the
module such that the field I/O connector is just above the mating
connector.
3.)
Verify that the two connectors are properly aligned. Once alignment is
achieved, you can fully seat the connector. It will snap into place. Install
two M2.5 screws as shown.
