Y1-03-0241C
15
4. Battery witness seal failure
If your beacon flashes an initial red LED at the beginning of the Self-
test, this indicates that your electronic witness has been broken and you
have used more than the allotted battery life for self-testing. While the
beacon will still operate normally in a distress situation, ACR strongly
recommends you have your battery replaced and the electronic witness
reset to ensure that you will have 24 hours of battery power.
5. GPS acquisition test
This test is NOT required as 100% of all GPS receivers that leave ACR
have been tested to ensure they perform correctly. However, if you would
like to ensure your GPS receiver is working, please follow these
instructions very closely.
CAUTION:
The following test should not be performed more than
twelve times during the life of the battery pack. Once this GPS testing
feature reaches 12 times, the feature will be disabled by internal software
until the battery is replaced.
NOTE:
The GPS receiver is located under the bottom front portion of the
case. It is imperative that the receiver is not obstructed during the GPS
acquisition test or activation to ensure that the GPS receiver is acquiring
your latitude (LAT) and longitude (LON) position. This test must be
performed outside with a clear view of the sky.
Press the Self-test button for greater than 5 seconds. Observe the beacon
for the entire GPS test. A beep and green LED will indicate that the GPS
has been turned ON. The beacon will beep every 5 seconds and the GPS
will remain ON until LAT/LON coordinates have been obtained or until 2
minutes have elapsed. If good LAT/LON data has been obtained, a single
406 MHz test signal will be sent out with location data and the GPS will be
turned OFF and the green LED will light for at least 3 seconds along with a
long beep. This LAT/LON data is
not
saved for use. The green LED
indicates that the GPS is functioning properly and that the beacon is in a
location or environment where it can receive the necessary signals from
satellites. If the GPS does not acquire good LAT/LON data, the GPS will
turn OFF after 2 minutes, followed with a RED LED light up for 3 seconds
along with a long beep, and no 406 MHz signal will be sent out.
GPS Test Sequences (max. 2
minutes 50 seconds)
GPS Test Guide
Green LED and beep at start
followed by continuous beeps every 5
seconds,
Green LED & Long beep
Successfully acquired GPS
data, 406 MHz signal sent out
with location data
Green LED and beep at start
followed by continuous beeps every 5
seconds,
Red LED & Long beep
GPS data was not successfully
acquired, no signal sent out.
Summary of Contents for AquaLink 2883
Page 1: ...Y1 03 0241C i...
