ACP ARX51 Series, Service Manual

Page: 8 / 39

INSTALLATION
STEP 1 - Unpack Oven
A. Inspect oven for damage such as dents in door or inside oven cavity.
B. Report any dents or breakage to source of purchase immediately.
Do not attempt to use oven if damaged.
C. Remove all packing materials from oven interior.
D. If oven has been stored in extremely cold area, wait a few hours before
connecting power.
STEP 2 - Place Oven on Counter
E. Recommended countertop surface depth is 28in (72 cm).
F. Do not install oven next to or above source of heat, such as a pizza
oven, grill, or deep fat fryer. This could cause oven to operate
improperly and could shorten the life of electrical parts due to
excessive heat and/or grease.
G. Do not block or obstruct oven filters. Allow access for filters to be
cleaned.
H. Install oven on level countertop surface.
I.
Outlet should be located so that plug is accessible when oven is in
place. Oven cord length is 60in (152cm)
STEP 3
– Test Oven Operation
J. Ensure cooking plate is installed.
1. Oven cavity must be cool to touch.
2. Place shelf in oven with curve positioned toward the
the front of the oven. This ensures proper convection air flow.
K.
DO NOT
cook food directly on floor of oven.
6
A. Allow at least 2in (5.1cm) of clearance around top
of oven. Proper air flow around oven cools
electrical components. With restricted air flow,
oven may not operate properly and life of electrical
parts is reduced.
B. Do not remove back panel bumpers. They ensure
proper clearance.
C. Allow at least 1in (2.54cm) of clearance around
sides of oven.
D. Install oven so oven bottom is at least 3 feet
(91.5cm) above the floor.