ACP ARX51 Series, Service Manual

Page: 26 / 39

Once the Service Mode is initiated a menu of options and information is displayed. The menu screen can be
navigated by swiping up or down if needed. Some components can be activated from this menu
– See
example of Magnetron 1 (Right Side) below, by touching start to start or stop to stop.
Pressing the “back
arrow” will return back on screen. Pressing the “home” icon returns to opening screen.
Service Mode Purpose Comments
Oven Information
Provide service provider with door
cycles and magnetron tube hours of
operation
Press and the following will display:
Door Cycles:
Tube Hours:
Software Version
Displays the version of software and
firmware installed in the control
Press and the following will display:
SW:
EE:
App:
Magnetron 1
Right Side
System can be started and stopped
by pressing the Start or Stop icon.
The current amperage being drawn by the HV
system. 5 -12amps is considered normal. Look for
consistent reading with Magnetron 2 and Convection
Heater. This circuit is protected by fuse F3
Magnetron 2 (if)
Left Side
System can be started and stopped
by pressing the Start or Stop icon
The current amperage being drawn by the HV
system. 5 -12amps is considered normal. Look for
consistent reading with Magnetron 1 and Convection
Heater. This circuit is protected by fuse F4
PIN Code
1234