Page 4
4. Connecting AE22 Passive
5. Connecting AE22 Active
Each active AE22 must be connected to mains power
and signal cables. Diagram Three illustrates the rear
connection and control panel.
Mains Connection
Mains power is connected via the IEC socket on
the back panel. Ensure before connecting to the
mains supply that the voltage specified on the panel
corresponds to your local mains voltage. A mains fuse
is located adjacent to the mains socket. If the fuse fails
it must be replaced by one of the same specification.
Repeated mains fuse failure indicates a fault which
should be investigated by a qualified service engineer.
The AE22 power switch is also located adjacent to the
mains socket. Do not switch-on until all connections
have been made. Illumination of the front panel display
indicates that the AE22 is switched on.
Diagram Three
Signal Connection
The AE22 provides both balanced and unbalanced line-level signal inputs for
connection to the monitor outputs of the mixing desk, digital audio workstation or
computer audio interface. A three position switch provides 6dB of input sensitivity
adjustment.
The balanced input is via a three pin XLR socket and the unbalanced input via
a concentric 6mm mono jack socket. Always use high quality professionally
terminated signal cables. Do not plug or unplug signal cables while the AE22 is
switched on.
HF Adjust
Flat
Cut
Lift
Flat
Cut
Lift
Flat
Cut
Extend
0dB
-3dB
+3dB
MF Adjust
LF Adjust
Sensitivity
Line Input
Balanced XLR
Unbalanced Jack
AM022-04-06
POWER INPUT:
FUSE RATING:
INPUT POWER: 220W
SERIAL No.
Risque de choc electrique
Ne pas ouveré
ATTENTION
Risk of electrical shock
Do not open
CAUTION
This speaker is NOT
magnetically shielded
WARNING
No user serviceable parts
inside.
Consult Owners Manual
before use.
Operate in accordance with
Manufacturer’s instructions.
If in doubt refer to qualified
service personnel.
Designed and Engineered by
Acoustic Energy Ltd, England.
Made in Malaysia.
