I N S T A L L A T I O N I N S T R U C T I O N S
1
REMOVE MOP BASE CAREFULLY
FROM CARTON
AVOID STANDING
MOP SINK ON END
REMOVE PACKAGING
WITH CARE
ACORN
ACORN ENGINEERING
COMPANY
RECOMMENDED
1/4" SPACE
1/4"
GROUT EXPOSED
SIDES
DOTTED AREA IS
FOR MOP SINK
SUB FLOOR
SAND OR
MORTAR BED
3030-738-000 Rev. 08/02/18
HANDLING
Carefully remove
Mop Sink
from carton at
installation point. Avoid placing
Mop Sink
on
its edge. (This precaution will prevent
damage to corners of
Mop Sink
.)
METHOD FOR CHECKING FACE OF
Mop
Sink
FOR TRANSPORTATION DAMAGE:
A. Wipe face of
Mop Sink
with a wet cloth
(Water).
B. When the water evaporates, any slight
crack in the
Mop Sink
will be
noticeable.
TERRAZZO-WARE
Mop Sink
800-488-8999 or 626-336-4561
FAX 626-961-2200
P.O. BOX 3527 • CITY OF INDUSTRY, CA 91744-0527 (U.S.A.)
LEVELING
Level
Mop Sink
carefully. For proper
installation, establish a 1/4" clearance between
Mop Sink
and the walls. A layer of mortar or
sand must be placed in area where the
Mop
Sink
is to be installed. This procedure is
recommended in order to support
Mop Sink
should the sub floor be uneven. Grout should
be exposed along edges.
*NOTE: Inspect and test for proper
drainage.
NOTE:
Mortar or sand must cover the entire
area between
Mop Sink
and building floor.
WARNING!
DO NOT DROP MOP SINK OVER EXPOSED
PIPE.
It is advisable to remove drain pipe and set
Mop Sink
in place. Insert pipe through drain in
Mop Sink
back into “P” trap. Tighten with an
internal pipe wrench.
2
2
2
3
Mop Sinks
DO NOT DROP ON PIPE
REINSERT PIPE AND TIGHTEN
WITH AN INTERNAL WRENCH
REMOVE PIPE
FROM TRAP
