Acorn Superglide 130, User Manual

Page: 22 / 38

Acorn Stairlifts User Manual
ENGLISH
22
CARE AND MAINTENANCE
SLEEP MODE
If the stairlift is not parked on a charge point, or in the event of a power failure, the stairlift
will ‘beep’ continuously for approximately 60 seconds, after which the stairlift will enter
SLEEP MODE. Once in sleeping mode, the stairlift will ‘beep’ twice approximately every 40
seconds. The user can ‘wake’ the stairlift at any time by using the paddle controls
or remote control handset. Once woken, park the stairlift on a charge point as normal.
RESET
On certain occasions, it may be necessary
to reset the control board of the stairlift.
Switch the Battery Isolation Switch OFF
(see page 10), leave for 30 seconds, then
switch back on. This will reset the
fault codes on the display panel.
SAFETY EDGES
SERVICING
Should the stairlift become unoperational (displaying
‘E1’, ‘E2’, ‘E4’, ‘E5’) this could be due to one of the safety
edges being trapped. This can be overcome by
moving the stairlift back in the opposite direction
and removing the obstruction or simply tapping the
relevant safety edge gently.
If this doesn’t rectify the problem, contact your
authorized Acorn representative for further
assistance.
It is recommended that your stairlift is serviced every 12 months by your stairlift supplier
to ensure it remains safe and reliable. Your stairlift is designed to operate smoothly and
quietly. The equivalent continuous A-Weighted sound pressure level of this equipment
does not exceed 70db (A). For safety reasons, only Acorn specifi ed parts should be used.
Use of parts that are not Acorn approved could aff ect the safety of your stairlift.