REASSEMBLING THE ARCHIMEDES
Now reassemble the Archimedes:
1
If you have removed any Podules, re-install them in accordance with the supplier's instructions.
2
Slide the top cover of the Archimedes unit on from the rear, making sure that it is correctly
located in its slots. These slots are positioned one on each side of the lower case.
3
Replace the screws at the rear and side of the unit and tighten them up.
4
Connect up the monitor and keyboard etc and then plug in the mains supply.
TESTING THE UPGRADE
1
Switch on the monitor.
2
Hold down `R' on the keyboard and switch on your Archimedes.
3
If you get a rolling, broken picture displayed, then switch off your Archimedes, and complete
step 4 below.
4
Hold down `R' on the keyboard and switch on again. After approximately half a second the
monitor should display a stable picture of the Desktop.
The installation is now complete.
Use the mouse (as described in your new Welcome Guide) to select operation.
NOTE: To go straight into BASIC (rather than the Desktop) set the configuration to LANGUAGE 4
©Acorn Computers Ltd, 1987
Published by Acorn Computers Ltd
Part number 0476,350
Issue 1
4
