Acomdata EXTERNAL E5 HARD DRIVE USB 2.0, User Manual

Page: 32 / 86

1
1. If the screws and nuts are not already affixed to the stand, insert
the two screws through the two holes from the underside of the
stand. Screw a nut onto the end of each screw just far enough to
hold the nut to the screw. Do not tighten the nuts.
. With both screws and nuts in place, push down on each screw
head to make sure the screws extend through the holes as far as
they will go.
. Attach the stand to the Drive case by sliding the nuts through
the groove in the Drive case, entering from the backside of the
case. You cannot slide the stand in from the front of the case.
The stand is symmetrical so it does not matter which end you
insert first. Once
the nuts are in the
groove, position the
stand so that it is
centered with the
Drive case.
. While holding the stand in place with one hand, use a screw-
driver with the proper type and size head to tighten the screws.
Make sure the stand is firmly secured to the Drive case.