7
Figure 16: Insert Four 3.5” Drive Retention Screws
STEP 8.5: 5.25" DRIVE INSTALLATION IN THE MAIN
DRIVE BRACKET
If you want to install a 5.25" optical drive into the main
drive bracket, follow the steps below:
Step 1: Remove the front metal cover from the 5.25" drive
bay by removing the 4 front cover retention screws, on
both sides, two on each side, of the 5.25" drive bay.
Figure 17: Remove the 4 Retention Screws on the Sides
of the Main Bracket
Step 2: Slide a 5.25" optical drive into the drive bay.
Make sure the 4-pin power connector and the IDE/SATA
drive interface connector are facing the rear of the chassis.
Step 3: Secure the 5.25" optical drive to the drive bay by
inserting 4 retention screws (two on each side) through the
sides of the drive bracket and into the 5.25" optical drive.
Figure 18: Install a 5.25" Disk Drive into the Main Drive
Bracket
STEP 8.6: REINSTALL THE DRIVE BRACKETS
Once all the drives have been installed into the drive
brackets, reinstall the drive brackets into the chassis. To
reinstall the drive brackets into the chassis, please follow
the steps below:
Step 1: Place the main drive bracket into the chassis
making sure that the front of the 5.25" optical drives are
facing out of the chassis and the 4-pin drive power connec-
tors and IDE/SATA interface connectors are all facing the
rear of the chassis.
Step 2: Reinsert the 4 previously removed main drive
bracket retention screws.
Step 3: Correctly mount the side drive bracket onto the
main drive bracket making sure the 4-pin power connector
and IDE/SATA interface connector both face the rear of the
chassis; and the clip at the bottom of the internal HDD
bracket slots into the space between the clip on the right
side of the main drive bracket and the main drive bracket.
Figure 19: Clips Locations
