STEP 2
CHECK DIRECTION
Press UP or DOWN buttons and ensure blind is moving in correct direction.
If working correctly proceed to Step 3.
Press and release buttons.
UP/DOWN
TO CORRECT BLIND DIRECTION
Press button on motor head for 5 seconds to change orientation of blind.
Motor beeps & jolts to confirm change of direction.
Check blind direction again before proceeding to Step 3.
For instructional purposes, the following options have been shown:
Easy-Lock Chain Winder 'AC' Installation Brackets.
Top Fix installation.
'AC' Bracket Cover Caps
40mm Motor - Somfy.
Somfy Drive & Crown Wheels.
INSTALLATION
ROLLER BLINDS
40mm MOTORISATION
ENSURE 'NOTCH' OF CROWN WHEEL
LOCKS WITHIN GAP OF MOTOR HEAD.
ASSEMBLY INSTRUCTIONS
STEP 1:
Install
Crown Wheel
onto
40mm Motor
. Ensure 'notch' of
Crown
Wheel
locks within gap of
Motor Head
.
STEP 2:
Install
Drive Wheel
onto
40mm Motor
.
NOTE:
* For Elero Motors, use 'O' ring supplied by Elero to lock
Drive Wheel
to
40mm Motor
.
* For Gaposa Motors, use
Gaposa Retaining Clip
to lock
Drive Wheel
to
40mm Motor
.
* For Selve Motors, use plastic retaining clip supplied by Selve to lock
Drive Wheel
to
40mm Motor
.
STEP 3:
Mount
40mm Motor Disk Adaptor
onto
Motor head
with
Counter
Sunk Screws
.
ONLY USE WITH GAPOSA
Page 57
P2 (x1)
UP (x1)
P2 (x1)
a. Set desired upper limit position, using the UP button.
Press DOWN to readjust blind to desired position.
b. When a more accurate setting is required put motor in
stepping mode by pressing UP+STOP at the same time while
motor is moving UP/DOWN
c. Once blind is at desired position press STOP for 5 seconds until motor jolts.
Motor will jolt to confirm limit.
UP/DOWN
STOP
(for 5 secs)
UP/DOWN
STOP
(for 5 secs)
Refer Page 3 for instructions.
P2 (x1)
P2 (x1)
DOWN (x1)
P2 (x1)
P2 (x1)
STOP (x1)
Page. 4
a. Press P2 button once
b. Press UP button once
c. Press P2 button once
STEP 3
PUT MOTOR IN LIMIT SETTING MODE
STEP 4
SET UPPER LIMIT
a. Set desired lower limit position using the DOWN button.
Press UP to readjust blind to desired position.
b. When a more accurate setting is required put motor in
stepping mode by pressing UP+STOP at the same time
while motor is moving UP/DOWN
c. Once blind is at desired position, press STOP for 5 seconds until motor jolts.
Motor will jolt to confirm limit.
STEP 5
SET LOWER LIMIT
C A N C E L L I M I T S
R E T U R N T O F A C T O R Y S E T T I N G S
a. Press P2 button once
b. Press DOWN button once
c. Press P2 button once
a. Press P2 button once
b. Press STOP button once
c. Press P2 button once
FOR AUTOMATE Q S45 & S60 MOTOR ONLY
S E T F A V O U R I T E P O S I T I O N
