PROGRAMMING A SINGLE CHANNEL WALL MOUNTED REMOTE IN 5 SIMPLE STEPS
S I N G L E C H A N N E L R F 4 0 1 R E M O T E O V E R V I E W
UP
STOP
DOWN
B E F O R E YO U B EG I N:
PLACE CR2450 (3V) BATTERY INTO REMOTE AND CHECK
ALL MOTORS ARE SWITCHED OFF WHEN PRESSING
BUTTON SEQUENCE ALWAYS PRESS AND RELEASE
EACH BUTTON
STEP 1
PAIRING A MOTOR TO A REMOTE
a. Switch Motor Power On (motor will beep)
b. Ensure pairing commences within 10 seconds after motor
has completed beeps and jolts
c. Press UP + STOP at the same time, twice
d. Press UP button once
Motor will beep when each button is pressed and to confirm pairing it will beep 3 times and jolt.
STEP 2
CHECK DIRECTION
Press UP or DOWN buttons and ensure blind is moving in correct direction.
If working correctly proceed to Step 3.
Press and release buttons.
UP/DOWN
TO CORRECT BLIND DIRECTION
Press button on motor head for 5 seconds to change orientation of blind.
Motor beeps & jolts to confirm change of direction.
Check blind direction again before proceeding to Step 3.
For instructional purposes, the following options have been shown:
Easy-Lock Chain Winder 'AC' Installation Brackets.
Top Fix installation.
'AC' Bracket Cover Caps
40mm Motor - Somfy.
Somfy Drive & Crown Wheels.
INSTALLATION
ROLLER BLINDS
40mm MOTORISATION
ENSURE 'NOTCH' OF CROWN WHEEL
LOCKS WITHIN GAP OF MOTOR HEAD.
ASSEMBLY INSTRUCTIONS
STEP 1:
Install
Crown Wheel
onto
40mm Motor
. Ensure 'notch' of
Crown
Wheel
locks within gap of
Motor Head
.
STEP 2:
Install
Drive Wheel
onto
40mm Motor
.
NOTE:
* For Elero Motors, use 'O' ring supplied by Elero to lock
Drive Wheel
to
40mm Motor
.
* For Gaposa Motors, use
Gaposa Retaining Clip
to lock
Drive Wheel
to
40mm Motor
.
* For Selve Motors, use plastic retaining clip supplied by Selve to lock
Drive Wheel
to
40mm Motor
.
STEP 3:
Mount
40mm Motor Disk Adaptor
onto
Motor head
with
Counter
Sunk Screws
.
ONLY USE WITH GAPOSA
Page 57
a. Press UP + STOP buttons at the same time
b. Press UP button once
c. Press UP + STOP buttons at the same time
UP & STOP (x1)
UP (x1)
UP & STOP (x1)
a. Set desired upper limit position, using the UP button.
Press DOWN to readjust blind to desired position.
b. When a more accurate setting is required put motor in
stepping mode by pressing UP+STOP at the same time while
motor is moving UP/DOWN
c. Once blind is at desired position press STOP for 5 seconds
until motor jolts.
Motor will jolt to confirm limit.
UP/DOWN
STOP
(for 5 secs)
UP & STOP (x2)
UP (x1)
Page. 2
STEP 3
PUT MOTOR IN LIMIT SETTING MODE
STEP 4
SET UPPER LIMIT
