V
V
FRONT
BACK
P2
(Program Bu on)
Ba ery Slot
(CR2430 ba ery)
Channel
UP
STOP
DOWN
BACK
P
(
B
(
FRONT
Channel
Display
UP
Channel Selec on
DOWN
STOP
SINGLE CHANNEL REMOTE
FRONT
v
v
BEFOR E YOU BEGIN:
PLEASE READ INSTRUCTIONS BEFORE USE
PLACE CR2430 BAT TERY INTO REMOTE
1
PAIRING MOTOR TO REMOTE
CHECK BLIND DIRECTION
2
3
SETTING UP/DOWN LIMITS
SET UPPER LIMIT FIRST
4
P R O G R A M M I N G A M O T O R
1a. Press P2 bu on ( x 2 )
1b. Press UP bu on ( x 1 )
V
V
P2 (x2)
UP (x1)
2a. Press UP & DOWN bu ons and ensure blind is moving
in correct direc on.
If working correctly proceed to Step 3.
V
V
UP / DOWN
2c. Switch power o
ff
for 10 seconds, then switch back on.
2d. Press P2 bu on ( x 2 )
2e. Press DOWN bu on ( x 1 )
Motor will beep x4
Ɵ
mes and jolt.
V
V
P2 (x2)
DOWN (x1)
V
V
P2 (x1)
UP (x1)
P2 (x1)
PUT MOTOR IN LIMIT SETTING MODE
3a. Press P2 bu on (x1)
3b. Press UP bu on (x1)
3c. Press P2 bu on (x1)
V
V
V
V
UP
Hold STOP for 5 sec
V
V
V
V
DOWN
Hold STOP for 5 sec
4a. Set desired upper limit posi on
fi
rst.
(using UP and DOWN bu ons)
4b. Press STOP for 5 seconds un l
motor con
fi
rms posi on.
TIP
When a more accurate se ng is required the motor can move up/down in a stepping mode, rather than
con nuously. To put motor in stepping mode: While motor is moving up/down, press P2 bu on.
This will cause motor to move up/down step by step.
Motor will beep with each bu
Ʃ
on pressed.
To con
fi
rm pairing, motor will beep x3
Ɵ
mes
and jolt up and down.
TO CORRECT BLIND DIRECTION
2b. Press bu on on motor
head for 5 seconds to change
orienta on of blind.
Motor beeps & jolts to
con
fi
rm change of direc
Ɵ
on.
To con
fi
rm limit, motor will jolt down and up.
4c. Set desired lower limit posi on
(using UP and DOWN bu ons)
4d. Press STOP for 5 seconds un l
motor con
fi
rms posi on.
SET LOWER LIMIT
LIMITS ARE NOW CONFIRMED AND BLIND IS READY FOR USE
FIVE CHANNEL REMOTE
MULTI CHANNEL REMOTE
FRONT
ALL REMOTES
•
Switch motor power on
(motor will beep x4 mes & jolt)
•
Ensure pairing commences within 10
seconds of turning motor on.
OPTION 1
OPTION 2
Re-con
fi
rm Step 2a.
FRONT
V
V
V
V
To con
fi
rm se
ƫ
ng mode, motor will beep
x3
Ɵ
mes and jolt up and down.
Channel
UP
STOP
DOWN
Channel Selec on
R E M O T E O V E R V I E W
