www.ACME-online.de
ACME the game company
Make sure that all tail parts are safely screwed. These parts are sharpened edges that ensure the
dynamics of the boat on the water. Also check the tube of the water cooling which leads out of the boat
and the rudder movements.
Place the boat on the water.
Start with reduced speed and drive slowly. Do not drive too far away from the shore.
As soon as you have a safe feeling, you can drive at full speed.
Once you notice the engines running low, you should return the boat to the starting point because the
batterie’s capacity is almost empty. Never drain the battery completely. This leads into a deep
discharge.
Once you have returned the boat safely, you should disconnect the battery. Then switch off the
controller. Make sure that no water gets inside, always dry the boat after use.
Controls
Acceleration
To drive forward, pull the trigger/gas lever into your direction. The stronger you pull, the faster it runs.
The model has no reverse gear!
Directions
To drive to the right, turn the wheel forward (clockwise).
To drive left, turn the wheel backwards (counterclockwise).
Break
Stop the boat by pushing the trigger forwards.
Please note that these directions are described from driver’s view – meaning from behind.
If the boat is driving towards you, you need to reverse the commands.
Alternate control
If you prefer an alternate control of the direction commands, you can use the switch ST.REV.
The function of the wheel is then reversed, meaning the boat is driving to the left when moving the
wheel forwards and driving to the right when moving the wheel backwards.
Rudder deflection
If you like to modify the rudder deflection, you can use the Dual rate switch that is located on the upper
Side. Please note: The lower the deflection is, the lower the boats latitude will be. As a beginner, you
can reduce the rate to slowly test the boat. You can higher the rate by turning the switch to front (7:3).
Direction- and gas trims
To fine- adjust the L/R- movements, put the wheel into neutral position and push ST.TRIM. Pushing it
down modifies the left- movements, pushing it up adjusts the right- movements.
You can set the gas trims with TH.TRIM. Put the trigger into neutral position and use the TH.TRIM
switch accordingly.
Binding
Controller and model are normally paired out of the box. If this is not the case or binding is lost, please
perform the following steps:
