ACME Zoopa Seventy, Manual

Page: 11 / 30

zoopa seventy
11
E
N
G
L
IS
H
The controller MODE 2
Channel switch Power switch
Gas stick
(up & down)
Pitch / Tail stick
(forward & backward, right & left)
Charging plug
IR
Charging LED
Power LED
Tail trimming
Charging of the helicopter
The helicopter is being charged by the controller. Make sure that the!
helicopter!and!the!controller are switched off in advance!
»
Connect the charging jack of the helicopter with the charging plug of
the controller.
»
Now switch on the controller. The helicopter has to be switched off
while charging!
During charging, the red LED is blinking and the green LED is on
permanently. Charging is finished as soon as the green LED stops flashing.
This procees takes around 25- 30 minutes.
!!
Please!note!that!only!full!and!new!batteries!are!able!to!charge!the!helicopter.!If!charging!is!finished!earlier!than!expected,!
the!controller!batteries!need!to!be!replaced!
Preparation
»
Open the battery cover on the bottom of the controller and insert the batteries (not included).
»
Insert batteries into the controller (batteries not included).
»
Place the helicopter on an even surface, so that the tail rotor points into your direction. Check if any obstacles could affect the
flight.
» Step back for at least one metres.
»
Switch on the controller and move the accelerator forwards.
» Switch on the controller and move the gas stick down at first, then up and again down – now the helicopter is ready for take off!