4. POWER SWITCH:
Turns On/Off the power;
5. ETHERNET:
Transfers fixture’s information to a main controller;
6. DMX IN:
DMX 512 operation, use 5-pin XLR cable to link the unit and DMX controller;
7. DMX IN:
DMX 512 link, use 3-pin XLR cable to link the unit and DMX controller;
8. DMX OUT:
DMX 512 operation, use 5-pin XLR cable to link the next units;
9. DMX OUT:
DMX 512 operation, use 3-pin XLR cable to link the next units;
9. BATTERY DISPLAY:
Shows the battery status;
10. USB:
11. FUSE
(AC250V/T 15A)
:
Protect the unit from damage of over voltage or short circuit;
12.
POWER:
Connect to the mains supply;
4. Lamp
4.1 Lamp
OSRAM:
1.
Because of its high internal pressure, there might be a risk that the Discharge lamp would
explode during operation. The lamp emits intense UV radiation which is harmful to the eyes
and skin. The high luminance of the arc can cause severe damage to the retina if you take a
close look at the lamp.
2.
To protect the lamp, always turn off the lamp first (via control panel or DMX controller) and let
the unit run at least five minutes to cool down before switching off the mains supply. Never
handle the lamp or luminary when it is hot.
A
6