Fixture Hours
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the number of working hours of the unit. To go back to the
main functions press the
MENU
button.
Software version
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the software version of the unit. To go back to the main
functions press the
MENU
button again.
5. How To Control The Unit
You can operate the unit in two ways:
1. By master/slave built-in preprogram function
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will move all the motors to
their ‘home’ position and you may hear some noises for about 20 seconds. After that the unit
will be ready to receive DMX signal or run the built-in programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit or master unit will control the
other units to give an automatic light show. This function is good when you want an instant
show. You have to select
(show 1) or
(show 2) or
(show 3)
…
or
(show 16) for the first unit. Its DMX input jack will have nothing plugged into it. The
other units will automatically be slave units, their DMX input jacks will connect with the DMX
output jacks of the last units.
5.2 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX 512 address.
8A
Summary of Contents for VB-4-10FC
Page 6: ...5A ...
Page 11: ...6 DMX512 Configuration 4 5 7 channels mode 10A ...