Blue
Enter offset mode, Select
Blue
, press the
ENTER
button to confirm, the present position will blink
on the display, use the
UP
/
DOWN
button to offset the value from 0 to 1000, press the
ENTER
button to store. Press the
MENU
button to exit.
White
Enter offset mode, Select
White
, press the
ENTER
button to confirm, the present position will blink
on the display, use the
UP
/
DOWN
button to offset the value from 0 to 1000, press the
ENTER
button to store. Press the
MENU
button to exit.
6. Control By Universal DMX Controller
6.1 DMX512 Connection
1. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120-ohm 1/4W
resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the
DMX-output of the last unit.
2. Connect the unit together in a “daisy chain” by XLR plug cable from the output of the unit to
the input of the next unit. The cable cannot be branched or split to a “Y” cable. DMX 512 is a very
high-speed signal. Inadequate or damaged cables, soldered joints or corroded connectors can
easily distort the signal and shut down the system.
3. The DMX output and input connectors are pass-through to maintain the DMX circuit, when
one of the units’ power is disconnected.
18E
Summary of Contents for Thunder
Page 1: ......
Page 11: ...10E ...
