2D
1. Safety Instructions
WARNING
Please keep this User Manual for future consultation. If you sell the
fixture to another user, be sure that they also receive this instruction booklet.
Please unpack and check carefully there is no transportation damage before
using the fixture.
Please disconnect main power before servicing and maintenance.
The unit must be installed in a location with adequate ventilation, at least 50cm
from adjacent surfaces. Be sure that no ventilation slots are blocked.
The maximum ambient temperature is Ta: 40
℃
. DO NOT operate it where the
temperature is higher than this.
DO NOT connect the device to any dimmer pack.
The housing must be replaced if they are visibly damaged.
Unit surface temperature may reach up to 85
℃
. Don’t touch the housing
bare-hand during its operation. Turn off the power and allow about 15 minutes
for the unit to cool down before replacing or serving.
There are no user serviceable parts inside the fixture. Do not open the housing
or attempt any repairs by yourself. In the unlikely event your fixture may require
service, please contact your nearest dealer.
Please read the instructions carefully which includes important
