11A
4.3 DMX Controller
Use universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
is showing on the display. Pressing ENTER
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically one minute later. To go back to the
functions without any change press the MENU button again. If you use please refer to the
following diagram to address your DMX512 channel for the first 4 units.
3 channels
：
5. DMX512 Configuration
4A
y
Do not allow children to operate the fixture.
y
Do not touch any wire during operation as there might be a hazard of electric shock.
y
Avoid power wires together around other cables.
y
Disconnect mains power before fuse/lamp replacement or servicing.
y
Replace fuse only with the same type.
y
In the event of serious operating problem, stop using the unit immediately.
y
Never turn on and off the unit time after time.
y
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
y
Do not open the unit as there are no user serviceable parts inside.
y
Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical assistance
center.
y
Disconnect the mains power if the fixture is not used for a long time.
y
Do use original packing materials once transport it again.
y
Do not look directly at the LED light beam while the fixture is on.
2. Technical Specifications
y
Voltage
：
AC 100-240V~ 50/60Hz
y
LED: 1X50W LED
y
Fuse: T 6.3A
y
Power consumption
：
80 W
y
Dimension
：
279 x226 x 191 mm
y
Weight
：
4 kg/pcs
For power supply, do not connect in series much more than 7 units, use another
mains supply for next 7 units.
