DMX SWITCH PACK
CA-416
INSTALLATION
TROUBLESHOOTING
CAUTION
POWER CONNECTIONS
2-
The switch pack is equipped with 4 DMX channels, it can be controlled by universal DMX controller, and
each channel can be used for the ON/OFF control for different equipment, such as lighting effects. It will be
"ON" when the DMX value is above 130, and "OFF" when the DMX value under 120, the LED
will show the state of each channel on the front and back panel. If you use a universal DMX controller
to control the switch pack, you have to set DMX address so that the unit can receive DMX signal.
- Start the address
.
Select the channels of DMX controller.
.
Dip switches:
.
Examples:
Channel 1: dip /on: #1 (=1)
Channel 5: dip /on: #1, #3 (1+4=5)
Channel 9: dip /on: #1, #4 (1+8=9)
Channel 13: dip /on: #1, #3, #4 (1+4+8=13)
Dip
#1
#2
#3
#4
#5
#6
#7
#8
#9
Value
1
2
4
8
16
32
64
128
256
13
9
5
1
Channel
4
3
1
2
Unit
ON
ON
ON
ON
Dip Switch Setting
3
3
2
1
1 2
5
4
7
6
8 9
5
4
6
8
7
9
3
3
1 2
1 2
5
4
6
5
4
6
8
7
9
8
7
9
- If the switch pack is not functional check main power supply is "'ON" and check the fuse.
- If the switch pack is functional but equipment ( light fixture ) does not light on - check if lamp works properly
or check if the DMX address is correct.
- If after trying these solutions, you still have a problem contact your dealer for technical assistance.
- Do not splash water or other liquids into or onto your unit.
- Always disconnect the main power before serving, repair or fuse replacement.
- Never open the unit while in use.
- No user serviceable parts inside please refer to the nearest authorized technical assistance office
for service.
The unit is supplied with a power plug appropriate to its voltage and destination. Should any other
connections be required they must be carried out with the following configuration.
Earth = Green/Yellow cable
Neutral = Blue cable
Live = Brown cable
Always unplug the CA-416 from mains power before
servicing the fixtures that are connected to CA-416!
