EN
GLISH
19
3D HELI MASTER
3D HELI Master
Helicopter battery
How to charge the helicopter’s battery. Instructions
1. Connect the adaptor plug to the mains.
2. Connect the adaptor to the battery charger.
3. Provide the required charge current to your battery. You can choose between 0.1 ampere (amps), 0.5 amps and 0.7 amps by pressing
the “SELECT” button (For Blizz 200 3D select 300 mAh battery).
4. Connect the battery with the charger.
5.
Start charging by pressing the “START” button on the charger.
6.
The selected AMPS LED flashes.
7.
Charging is complete when the power LED as well as the chosen ampere LED are flashing..
LED functions under normal operation
Single power LED
shows current charge
Single AMPS LED flashing
charging
Multiple LEDs flashing
charge complete
How to insert the flight battery
Insert the flight battery into the helicopter’s battery holder. Only connect the battery with the battery cable after you have switched on the
controller. Make sure, that Pitch and Trim are in lowest idle position.
!
Do not use batteries by other producers. These might have another polarity and can damage the helicopter.
