-8-
LEDs definition
26 status LED indicate:
LED
Color
Description
Power 1
Green
This led is ON when a power supply is connected to
pin PWR1 and GND1 of the power connector.
Power 2
Green
This led is ON when a power supply is connected to
pin PWR2 and GND2 of the power connector.
DIAG1
Red/
Green
When the C-Key is detected and its data is valid,
DIAG1 light up in green. If the data stored in the C-
Key if invalid or corrupted, DIAG1 lights up in red. It
stays OFF if no C-Key is installed.
DIAG2
Red/
Green
This LED lights up after initialization of the device,
and indicates the unit operational state:
RED: Product dysfunction.
GREEN: Product is fully operational.
C-KEY
Orange
This LED lights up upon C-KEY detection at power
up. Flashing during C-KEY transactions.
WLAN
Blue
Flashing according to WLAN Tx/Rx activity.
Bargraph
Green
In Bridge mode, the four bars show the receive level
of the WiFi interface. In AP mode, the four bars blink
until a client is connected.
Act/Spd/
Link
(ports 1-8)
Yellow/
Green
Lit when the link is established, blinks according to
TX/RX activity. The color indicates the connection
speed : yellow= 10 Mbps, green= 100 Mbps.
POE PSE
(ports 1-8)
Green
This LED lights up when the associate port provide
power over Ethernet to a remote device.
Resetting the WLg-Switch
If powering down the device is not
possible, you can use the reset button
accessible through an opening located
near the power connector. Use, for
example, a paper clip to press briefly
the button. If the pressure lasts more
than two seconds, this will restore the
product’s factory settings.
