- 14 -
LEDs definition
Each module has 8 status LED indicating:
LED Color
Description
Power 1
Green
This led is ON when a power supply is connected to
pin 3/pin 4 of the power connector.
Power 2
Green
This led is ON when a power supply is connected to
pin 1/pin 2 of the power connector.
Diag Red
This led indicates the unit operational state.
ON: Failed, OFF : OK. It stays ON for less than 10s
after power is applied then it goes OFF.
WLan
Tx/Rx
Blue
Flashing for WLAN Tx/Rx activity.
Lan 1
10
Green
Status for LAN1 network interface:
ON for LINK in 10 BASE T and flashing for Tx/Rx
activity.
Lan 1
100
Green
Status for LAN1 network interface:
ON for LINK in 100 BASE Tx and flashing for Tx/Rx
activity.
Lan 2
10
Green
Status for LAN2 network interface:
ON for LINK in 10 BASE T and flashing for activity.
Lan 2
100
Green
Status for LAN2 network interface:
ON for LINK in 100 BASE Tx and flashing for activity.
The 10 BASE-T or 100 BASE-Tx Half/Full duplex mode is negotiated
according to 802.3u recommendations.
Regulatory compliance
The unit conforms to the following council directives:
N° Title
1999/5/CE
Radio and Telecommunications Terminal Equipment
Directive (R&TTE)
73/23/CE
Low voltage directive
The device has been certified to comply with the European directives and is
appropriately CE marked.
N° Title
EN61000-6-2
EMC emission, industrial grade
EN61000-6-4
EMC Immunity, industrial grade
EN301-489-17
EMC for radio equipment 2.4Ghz & 5GHz
EN 301 893
Broadband Radio Access Networks (BRAN) ;
5 GHz high performance WLAN
Summary of Contents for DTUS063
Page 2: ...2...
